Arduino Nano Clone V3.0 ATMEGA328P - USB CH340 Chip (Original Clone) USB Cable Gift

Arduino Nano; It is a microcontroller board based on Atmega328. In this clone version of the Arduino Nano board, CH340 integrated circuit is used instead of standard FTDI or 16U2 chips.

Thus, the cost was reduced but there was no change in performance. It has approximately the same features as Arduino Duemilanove.

There is no DC power jack only. The Arduino Nano is powered via a Mini-B USB connection. It (automatically) selects the high voltage source as the power source. 

Arduino Nano 328; Based on ATmega328, it can be used with a small breadboard and different platforms.

It can be easily programmed via Arduino IDE.

Operating voltage is in the range of 5V - 12V. However, the recommended operating voltage must be more than 7V. 9V batteries will be sufficient for operation. 

Power pins are as follows:

VIN: Voltage input pin between 7-12V when using external power supply. 

5V: This pin gives 5V output from the regulator. If the card works only via USB (5V), the 5V coming from USB is directly output via this pin.

At the same time, 5V input can be made through this pin.  If power is supplied to the card via Vin (7-12V), 5V coming out of the regulator is directly output via this pin.

3V3: This is the output pin of the 3.3V regulator on the card. Max. It can output 50mA.

GND: These are ground pins.

TECHNICIAL SPECIFICATIONS:

Microcontroller: Atmel ATmega328,

Logic Voltage Level: 5V,

Input Voltage (recommended) 7V - 12V,

Input Voltage (limit) 6V - 20V,

Digital I/O Pins: 14 (6" are PWM pins),

Analog Input Pins: 8,

Current Provided from Each Pin: 40mA,

Flash Memory: 32KB (2KB is used by the bootloader),

SRAM: 1KB,

Operating Frequency: 16 MHz,

Product Dimensions: 17.5 x 43mm,

Windows 7 and Windows 8 support with CH340 Driver.

PACKAGE INCLUDED:

1 x Arduino Nano 328 CH340,

pins,

Note: Arduino Nano is shipped with all its pins.