1 Pc TPMS Reset Tool for GM Tire Pressure Monitor System Programming Training Activation Tool OEC-T5 EL 50448 Vehicle Series 2006-2023 Tire Repair Rubber Nail Set 20Pcs Small and 20Pcs Large

OverviewPackaging includes:
1 Pc TPMS Reset Tool
40Pcs Tire Repair Rubber Nail Set (Small and Large)
How to use EL 50448 TPMS Activation Tool
Step 1- Enter leaning mode
Set the gearshift lever to ""P""
Put the ignition switch to “ON”
Enter the interface of tire pressure display by DIC
DIC shows ""Press Set / Ctrl to re-learn""
Press “Set / Ctrl”
The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode
Step 2- Read tire pressure sensor information
Start from the front-left wheel,
Make the J-46079 or Diagnostic Tool EL-50448 antenna up against the valve core position & close to the rim of the tire sidewall
El-50448 tire pressure tool starts by the start switch
Successful to read the tire pressure sensor information when the horn bleeps once
Step 3- Same method to read other tire pressure information
Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.
For certain vehicles equipped with a Tire Pressure Monitoring (TPM) system, a ""Sensor Re-Learn Procedure"" must be performed after tire rotations, Remote Control Door Lock Receiver Module replacement or Tire Pressure Sensor replacement. This re-learn procedure can be performed by using special tool 50448