LED Light Drawing Tablet A4

Gvn Art Led Light Drawing Tablet

Installation and Operation:

1. Remove the transparent protective plastic film from the illuminated drawing tablet.
2. Connect the USB cable to the computer or 5V phone adapter.
3. Tap the On/Off dimmer located on the upper left.
4. Adjust the light level by pressing the On/Off dimmer. There are 3 levels, each touch changes one level.
5. Two red magnet pins secure the paper while drawing.

Attention:

Do not cut or use sharp tools on the work surface as this will scratch the surface. A clear cutting mat is recommended.


Important Safety Instructions:

This LEDIlluminated drawing tablet

1. Read and understand all instructions before use.
2. Supervision is required when used by or near children. Do not leave unattended while in use.
3.Do not use this equipment with a damaged power cord or if the unit has been dropped or otherwise damaged until it has been inspected by an electrician.
4.If an extension cord is required, make sure it has a suitable current rating. Any less amperage than this equipment may overheat.
5. Always unplug the equipment from the electrical outlet when not in use. Always unplug by grasping the power adapter and removing it from the outlet, never pull the cord to unplug as this may damage the adapter or outlet.
6. Do not immerse in water. If equipment is water damaged, do not use until inspected by an electrician.

Care :

Clean the surface with a soft cloth and a non-abrasive cleaner such as dish soap. Never apply cleaner directly to the Light Pad as it can seep into the unit and cause damage.