100A MPPT Solar Charge Controller 12V 24V 36V 48V LCD Display Auto Solar Cell Panel Charger Regulator, Max 100V Input Dual USB Efficient and Reliable Power Solution for Lead-Acid Lithium

Description:

solar charge controller with the most advanced MPPT control algorithm,

and the maximum power point of the pv array can be quickly tracked,

in any environment so that it can get the maximum energy from the solar panel and significantly improve,

the utilization of energy in solar system. It can be used in communication base station,

home power supply system, traffic light, solar street lamp, courtyard lamp systems, etc.Feature:

7 kinds of working mode selection

1. Charging mode: in any case, never discharge.

2. Light control mode: when the controller detects nights, it will delay ten minutes then start to discharge;

when it detects daytime, it will delay ten minutes then stop discharging.

3. Light and time delay control mode: when the controller detects nights,

it will delay ten minutes then start to discharge and count down, if the timer stops by zero, discharge will stop.

The longest duration of delay is 23:59.

4. Universal control mode: under the trouble-free condition, it always keep discharging.

5. Manual control mode: it uses “∆” for discharging or not.

6. Timing control mode: it opens or closes the discharge regularly.

7. Test mode: it is the same as light and time delay control mode but only loses ten minutes of time delay.

8. The controller still discharges under low voltage protection.

Touch-holding “∆” for 5 seconds, discharge continues to output.

But discharge is only stopped by hand. Notice that this performance may damage the battery, be careful with it!Controller parameter:

MODEL:SY6048

Battery Voltage:12V/24V/36V/48V Auto

Charging Current:60A

Max Solar Input(Voc):15-25V(12V Battery);30-50V(24V Battery);45-75V(36V Battery);60-100V(48V Battery)

Maximum PV Input power:720W(12V Battery);1440W(24V Battery);2160W(36V Battery);2880W(48V Battery)