Automotive Control Pen, Auto Circuit Leakage and Broken Installation Detection Tester, High Quality Topdiag P100 Pro tek

TopDiag P100 Pro:

• P100 Pro is the latest generation intelligent Electrical System Circuit Tester with 2.4 inch large size LCD screen.
• It is suitable for testing all 9V-30V vehicle electrical systems.
• There are two LED lights on the front end, which is more convenient to realize all kinds of services, including power injection, measurement, ground testing. polarity checks, continuity testing and activation of components. There is a setpoint voltage alarm if the circuitry connected to the probe tip forces the voltage to be up to 0.5 volts higher or lower than the setpoint voltage.
• The device will sound an alarm to let you know that the output voltage is different from the set voltage. It can be disconnected and check for short circuit or other faults.

General features:

1. Intelligent identification of voltage/resistance

2. Multimeter mode (measure voltage, resistance, diode, continuity)

3. Oscilloscope function

4. Frequency

5. Activation of vehicle components

6. 0-5V adjustable power supply

7. Updates available

Thanks to its easy-to-read Avometer, it allows you to read voltage, current and resistance at your fingertip. You can instantly identify positive, negative and open circuits. When you flip the power switch, cooling fans, relays, etc. You instantly have a ground line to run electrical components. With the gold-tipped conductive needle, you can instantly supply 12volt energy or chassis to any line you want without having to strip or cut any cables. It is extremely easy to use, practical and reliable.

Turbo pressure sensor, fuel level sensor, air flow meter-mass sensor, all sensors working with PWM, Commonrail pressure sensor, crank and camshaft sensors, accelerator pedal potentiometer-position sensor, etc. It allows you to interpret pedal values, alternator voltage, EGR valve position sensor, ABS speed sensor values ​​and the oscilloscope image of the frequencies of all similar sensors and communication lines, frequency measurements on CAN-BUS, LIN-BUS and K-Line lines in a very practical way.

Features:

Color: Green

Screen: 2.4 inches (320*240 DPI)

Operating temperature: 0-60C (32-140 F)

Storage temperature: 40-70C (-40-185 F)

External power supply: powered by 12V or 24V battery

Minimum working voltage: 9V

Maximum operating voltage: 30V

Maximum measurement voltage: 100V

Minimum measuring voltage: 0.1V

Resistance measurement range: 1 ohm~200K ohm

Active Current measurement range: 0 ~ 18A

Maximum continuous current: 18A

Weight: 1070g

Size: 17.6*24.6*7.6cm