ColorFabb PLA/PHA Filament  Sky Blue 1.75mm /750

OverviewPLA/PHA: colorFabb’s signature blend of bioplastics. A less brittle and stunning PLA filament. During the renaissance ultramarine was the most expensive pigment a painter could use. Our color inspired by the original ultramarine blue will make you 3D prints look Material: colorFabb PLA/PHA Diameter Tolerance:± 0.1 mm Density: 1.2 g/cm3 Glass Transition Temperature: 55C Advised 3D printing temperature: 195-220C Advised 3D print speed: 40 – 100 mm/s Advised Heated bed: 50-60C Cooling Fan: 100% fan cooling for best aesthetics, this gives best performance on overhangs and small details. For best mechanical performance try printing with the least amount of cooling needed, for optimal layer adhesion. Build platform: PLA/PHA performs well on both heated and non-heated build platforms. For those users printing on a cold build platform we advise applying masking tape to the build area. The rough surface of the tape will provide enough adhesion for the first layer to stick and print almost without any warping. Additional Instructions: PLA/PHA has very minimal warping tendencies, however if your printing parts which take up the maximum of you builds pace you might see some warping. If it’s very important that your part is perfectly flat than we suggest to turn down the fan that is cooling your part. This allows the material to slowly get rid of heat without warping. After a few centimeters you can turn on the cooling if the part needs it