FRA-BER -100% DEGREASING CONCENTRATED 4.54 Litre - Cleaning for the engine compartment, rims and tyres, flies, rubber mats and plastic surfaces - Made in Italy

OverviewFor the extraordinary cleaning of rims and tyres: Wait until the surfaces are cold or cool them with water. Spray the product and let it act for a couple of minutes. In the presence of heavy duty dirt, consider using a nylon bristle brush or similar to treat the affected areas. Rinse: you can rinse with high pressure water for stubborn dirt or when touchless cleaning is required. To clean the engine: Wait for the surfaces to cool. Dispense the product and let it act for a couple of minutes. In the presence of heavy duty dirt, consider using a brush to treat the affected areas. Wipe a damp microfibre cloth to remove the product. Cleaning hard plastic and internal surfaces: First vacuum dust and dirt carefully. Apply the product evenly, directly on the surface to be treated or, in case of heavy duty dirt, spray the product on a brush with soft bristles that will be used for it to be applied. If necessary, use a brush to remove the most stubborn dirt. Wipe a soft damp microfibre cloth to remove the product. For the routine cleaning of other parts:: Spray the diluted product on the surface. First wipe a damp microfibre cloth and then a dry one. For 100% Degreasing in the 500 ml ready-for-use format: For the extraordinary cleaning of rims/tyres, engine and interior hard surfaces: use the product undiluted. For the routine cleaning of other parts: the recommended dilution is 1:1; use 500 ml of product and add the remaining part of water (500 ml) to obtain 1 L of ready-for-use solution. For 100% Degreasing in the 4.54 l concentrated format: For the extraordinary cleaning of rims/tyres, engine and interior hard surfaces• : the recommended dilution ranges from 1:2 to 1:3; i.e. use 330 ml to 250 ml of product and fill the remaining part with water (670 ml - 750 ml) to obtain 1 L of ready-for-use solution. If used as a pre-wash: if applied with a precompression pump or bucket, the recommended dilution ranges from 1:20 to 1:30, i.e. use 50 ml to 30 ml of product and fill the remaining part with water (950 ml - 970 ml) to obtain 1 L of ready-for-use solution. If applied with a foam lance or foam gun: the recommended dilution ranges from undiluted to 1:2; use 350 ml of product and add the remaining part of water (650 ml) to obtain 1 L of ready-for-use solution. While dispensing, the actual final dilution can reach approximately 1:15 to 1:45. For the routine cleaning of plastics: the recommended dilution ranges from 1:10 to 1:20, i.e. use 90 ml to 50 ml of product and fill the remaining part with water (910 ml - 950 ml) to obtain 1 L of ready-for-use solution. For the routine cleaning of fabrics: the recommended dilution ranges from 1:5 to 1:40, i.e. use 150 ml to 25 ml of product and fill the remaining part with water (830 ml - 975 ml) to obtain 1 L of ready-for-use solution. Precautions: do not spray or apply the product on hot surfaces. On particularly delicate parts it is always recommended to test the product on hidden parts of the vehicle.