مستلزمات السيارات

إكسسوارات الديكور

المرايا الداخلية

My Tuning

Hyundai Starex Mirror Cover Abs Chrome 2 Pcs

د.إ.‏86.00

د.إ.‏ 139.50

(شاملة ضريبة القيمة المضافة ورسوم الاستيراد)

جاري الحفظ:

د.إ.‏ 53.50

خصم 38%

🌙 عرض رمضان الكبير

عروض البنوك

احصل على 5% رصيد مسترجع باستخدام بطاقة بنك المشرق نون الائتمانية. اشترك الآن.

الدفع المُسبق فقط

البائع

يتم البيع عبر

هيبسيبورادا

2.6

38% تقييم إيجابي للبائع

المنتج كما في الوصف

50%

إرجاع سهل لكل المنتجات في هذا العرض.

نظرة عامة على المنتج

نظرة عامة

MYTUNING

Product OFeatures:

Chrome products are molded specifically for the part of the vehicle where they will be applied. is produced

Chrome products are produced from A class quality stainless steel.

The products are sent ready for assembly with high quality double-sided acrylic tape on the back.

Installation Instruction:

1- Assemble in a dry and dust-free environment.

2- During installation, the ambient temperature must be between 15°C and 35°C. If the ambient temperature is below 15°C, do not use a hair dryer etc. on the surface. Install by heating.

3- Before removing the tapes of the part to be adhered, make an assembly test, starting from the oval and closed surface.

4- Clean the surface to be adhered meticulously with a cotton cloth, spirit or pure alcohol. After cleaning the surface to be bonded, dust and oil protect. DO NOT clean the surface to be adhered with oily and additive materials such as wet wipes, water, thinner, gasoline, diesel oil, cologne.

5- After applying the cleaning process to the surface to be bonded, wait for 5 minutes and start the bonding process.

6- Remove the protective surface of the double-sided tape on the product and assemble it again starting from the oval and closed surface.

7- In the assembly process, rub it over the product with a soft cloth or fingertips. One minute of printing on the piece and again a hair dryer, etc. Apply heat with the help of

ATTENTION

As the tape used will show its full properties within 24 hours, use the glued part carefully during this period.
In order not to loosen the adhered part, tape it with paper or packaging tape that you can remove after 24 hours.
Take care not to wash your car within 24 hours.