DALY Smart Truck Starts BMS 150A 4S 8S UART & CAN/RS485
Model Number : TRUCK START BMS
Was:
AED 699.00
Now:
AED 620.00 Inclusive of VAT
Saving:
AED 79.00 11% Off
Free Delivery
Only 5 left in stockFree DeliveryOnly 5 left in stock
Get it by 27 Dec
Earn AED 31.00 cashback with the Mashreq noon Credit Card. Apply now
Pay 4 interest-free payments of AED 155.00.Learn more
Split in 4 payments of AED 155.00. No interest. No late fees.Learn more
Size
1
Specifications
| Product Weight | 480 g |
| Colour Name | TRUCK START BMS |
| What's In The Box | Smart Truct Starts BMS *1 B-P-Output cables *1 set Screw *2 B+ Cable *1 NTC(2 ways) *1 Sampling Cable *1 CAN/485 5pin cable *1 BT switch *1 BT Module *1 Heating film connecting cable *1 Instruction card *1 |
| Product Length | 152 mm |
| Product Height | 90 mm |
| Product Width/Depth | 26 mm |
| Model Number | TRUCK START BMS |
| Model Name | TRUCK START BMS |
| Fitment Details | Wiring the BMS: 1. Connect the B- Cable: - Begin by connecting the B- cable of the BMS to the total negative pole of the battery pack. 2. Cell Wiring: - Start from the thin black cable connected to B-. - The second wire connects to the positive terminal of the first battery cell. - Continue connecting each cell’s positive terminal in sequence. - Finally, insert the B+ cable into the BMS and connect it to the positive terminal of the last cell. 3. Verify the Setup: - After completing the wiring, check if the green indicator light is on. - Use the Bluetooth app or PC software to check for any fault alarms. - Measure the voltages at B+ and B-. They should match the voltages of P+ and P-. If the voltages match, the BMS is functioning properly. If not, recheck and rewire according to the steps above. Removing the BMS: 1. Turn Off the Load Power: - Turn off the load power switch to prevent any electrical issues during disconnection. 2. Disconnect the Cables: - If there are two cables, start by pulling out the high-voltage cable first, followed by the low-voltage cable. - Then remove the P- cable from the BMS. 3. Final Removal of B- Cable: - Finally, disconnect the power line B- to complete the BMS removal process. |
DALY Smart Truck Starts BMS 150A 4S 8S UART & CAN/RS485
Added to cart
Cart Total AED 620.00
