Dr. Beckmann, Colour Run Remover, 1 Count

OverviewImportant information Safety Information Directions for Use - Please read Important Information before use & Essential Reading on the side of the pack In a container - preferably airtight Carefully cut open the sachet and completely dissolve the powder in approx. 6 litres of the hottest water the fabric care label will allow. Add up to 1.5 kg of discoloured washing and submerge fully (do not add any detergent). The washing must be completely submerged in the solution the entire time. Cover the container. Allow washing to soak for at least 4 hours. For best results, with tough colour runs and/or low temperatures (30/40 °C) allow washing to soak overnight, for up to 24 hours. Then rinse thoroughly several times with clean water, or wash separately in the washing machine. We recommend wearing rubber gloves when using the product. People with respiratory diseases should avoid using the product in containers. In the washing machine Load the drum with up to 3 kg of discoloured washing. Carefully cut open the sachet and pour the contents into the detergent draw. Select the maximum allowable temperature as stated on the fabric care label (do not add any detergent). Immediately commence main wash cycle. Do Not use economy, pre-wash or time delay cycles. Important Information Always follow the instructions on the fabric care label. Only use in a well ventilated room. Avoid breathing fumes. Take special care if suffering from asthma, bronchitis or allergies which affect breathing. Use the complete sachet. Do not store part-used sachets. Essential Reading: Dr. Beckmann Colour Run Remover for white garments is recommended for use on white garments Only. To avoid disappointment, if your garment contains any colour (or coloured motives) then you must test all the coloured areas first for colour fastness to this product, as there is no guarantee against colour loss. Colour Fastness Test: Carefully cut open the sachet. Dissolve 1 teaspoonful of powder in 100ml of hot water. Thoroughly moisten an inconspicuous area of each colour and fabric in the garment(s) with the solution. Let dry completely (min 1 hour but may take longer). If original colour or pattern of test area(s) remains unchanged, proceed with full treatment carefully following the instructions on the reverse of the pack.